fbpx

製品情報

Winstar 新商品 0.91インチ128×32液晶ELモジュール


型番
 WEO012832F

►薄板バージョン
►グラフィック液晶ELモジュール
►I2C ディスプレイ
►0.91インチ OLED
►結構: COG
►128 x 32 ドットマトリックス
►SSD1306BZコントローラー内蔵
►3V電源電圧
►1/32 duty
►インターフェース: I2C


製品情報

WEO012832FはCOG構造のグラフィックタイプ0.91 OLED I2C ディスプレイです。ウェアラブルに生かせます。 SSD1306BZ コントロールICを内臓して、I2Cのインターフェースをサポート致します。WEO012832FのAA寸法とVA寸法はWEO012832Dと同じですが、異なるインターフェースとFPCピン配列されております。WEO012832DはSPIのインターフェースをサポート致します。 I2Cのインターフェースを必要する場合、WEO012832Fをご選びください。

有機EL・COGモジュールは超薄、軽量、高コントラスト、低消費電力、広視野角、高速応答のメリットを有して、壁取付け式デバイス、ハンドヘルド機器、メーター、スマートグリッド、ウェアラブル機器、IoTシステムなどに生かせます。 操作温度範囲は–40℃ to +80℃で、保存温度範囲は -40℃ to +85℃となっております。

  • WEO012832FWPP3N00001 : 白色
  • WEO012832FLPP3N00001 : 黄色

外形図

製品仕様

ピン功能定義

No. 記号 功能説明
1 C2P Positive Terminal of the Flying Inverting CapacitorNegative Terminal of the Flying Boost CapacitorThe charge-pump capacitors are required between the terminals. They must be floated when the converter is not used.
2 C2N
3 C1P
4 C1N
5 VBAT Power Supply for DC/DC Converter Circuit
This is the power supply pin for the internal buffer of the DC/DC voltage converter. It must be connected to external source when the converter is used. It should be connected to VDD when the converter is not used.
6 NC No connection
7 VSS Ground of Logic Circuit
This is a ground pin. It acts as a reference for the logic pins. It must be connected to external ground.
8 VDD Power Supply for Logic
This is a voltage supply pin. It must be connected to external source.
9 RES# Power Reset for Controller and Driver
This pin is reset signal input. When the pin is low, initialization of the chip is executed.
10 SCL I2C mode is selected, D2, D1 should be tied together and serve as SDAout, SDAin inapplication and D0 is the serial clock input, SCL.
11 SDA
12 IREF Current Reference for Brightness Adjustment
This pin is segment current reference pin. A resistor should be connected between this pin and VSS. Set the current lower than 12.5μA.
13 VCOMH Voltage Output High Level for COM Signal
This pin is the input pin for the voltage output high level for COM signals. A capacitor should be connected between this pin and VSS.
14 VCC Power Supply for OEL Panel
This is the most positive voltage supply pin of the chip. A stabilization capacitor should be connected between this pin and VSS when the converter is used. It must be connected to external source when the converter is not used.

規格説明

項目 仕様 単位
ドットマトリックス(解像度) 128 × 32 Dots
モジュールサイズ 30.0 × 11.5 × 1.26 mm
有効エリア 22.384 × 5.584 mm
ピクセルサイズ 0.152 × 0.152 mm
ピクセルピッチ 0.175 × 0.175 mm
表示モード Passive Matrix パッシブマトリクス
発光色 モノクロ
駆動方法 1/32 Duty
IC SSD1306BZ
インターフェイス I2C
サイズ (対角線) 0.91 インチ

絶対最大定格

パラメーター 記号 最小値 最大値 単位
ロジック電源電圧 VDD 0 4.0 V
Display電源電圧 VCC 0 16.0 V
操作温度 TOP -40 +80 °C
保存温度 TSTG -40 +85 °C

電気特性

DC 電気特性

項目 記号 条件 最小値 典型値 最大値 単位
ロジック電源電圧 VDD 2.8 3.0 3.3 V
Display電源電圧 VCC 7 7.25 8 V
高レベル入力 VIH 0.8×VDD VDDIO V
低レベル入力 VIL 0 0.2×VDD V
高レベル出力 VOH 0.9×VDD VDDIO V
低レベル出力 VOL 0 0.1×VDD V
VCC 動作電流 (VCC Supplied Externally) ICC Vcc =7.25V 7 11 mA

関連記事

  1. この記事へのコメントはありません。

  1. この記事へのトラックバックはありません。

ピックアップ

  1. Winstar製品 5.6 インチ HD (高解像度) IPS ディスプレイ: eDP インターフェイス

  2. Winstar製品 8インチ垂直画面 800×1280 TFT-LCDディスプレイモジュール

  3. Winstar製品 800×1280 8インチ TFTタッチスクリーンディスプレイ (RTP)

  4. Winstar製品 800×1280 8インチ TFTタッチスクリーンディスプレイ (PCAP)

おすすめ記事

ページ上部へ戻る