7.212022
Winstar製品 3.5 インチ 320×480 MIPI IPS PCAPタッチパネル TFT ディスプレイ
型番 WF35UTYAIMNG0
►サイズ: 3.5インチ
►解像度: 320×480 dots
►視野角: IPS
►インターフェース: 1-Lane MIPI
►IC: ILI9488
►コントロールボード:無
►輝度(cd/m²): 500
►スルーホールフレーム: 無
►タッチパネル: PCAP静電容量タッチパネル
►検出ポイント: 5
特 長
WF35UTYAIMNG0は3.5インチで、IPS TFT-LCD モジュールで、解像度は320×480 です。ILI9488 ドライバ ICを内蔵し、MIPI とDSI インターフェイスをサポート致します。輝度は500ニット(標準値)で、コントラスト比は700:1(標準値)です。
WF35UTYAIMNG0は投影型静電容量タッチパネル(PCAP)を搭載しており、GT911 ドライバ ICを内蔵し、 I2C インターフェイスをサポート致します。電源電圧は2.8V~3.3Vです。タッチパネルなしのWF35UTYAIMNN0も提供しております。
この3.5インチTFT LCDモジュールは、IPS(面内スイッチング)パネルを備えたポートレートモードで、広視野角という利点を持ちます。視野角は左: 80 /右:80 /上:80 /下:80度 (標準値)で、操作温度範囲は-20℃~+70℃で、保存温度範囲は-30℃~+80℃です。
図 面
製品仕様
ピン功能定義
LCM PIN 定義
NO | 記号 | 説明 | I/O |
---|---|---|---|
1 | VCI | A supply voltage to the analog circuit. Connect to an external power supply of 2.5 ~ 3.3V. Connect to a stabilizing capacitor between VCI and GND. |
P |
2 | IOVCC | A supply voltage to the digital circuit. Connect to an external power supply of 1.65 ~ 3.3V. | P |
3 | RESET | Reset input signal Initialize the chip with a low input. Be sure to execute a power-on reset after supplying power. |
I |
4 | GND | Ground | I |
5 | MIPI_CLK_P | Positive polarity of low voltage differential clock signal Leave the pin open when not in use. | I |
6 | MIPI_CLK_N | Negative polarity of low voltage differential clock signal Leave the pin open when not in use |
I |
7 | GND | Ground | I |
8 | MIPI_DATA_P | Positive polarity of low voltage differential data signal Leave the pin open when not in use. |
I |
9 | MIPI_DATA_N | Negative polarity of low voltage differential data signal Leave the pin open when not in use. |
I |
10 | GND | Ground | I |
11 | VLED+ | Anode of LED backlight. | |
12 | VLED- | Cathode of LED backlight |
PCAP PIN 定義
Pin | 記号 | 説明 |
---|---|---|
1 | VSS | Connect to system ground. |
2 | VDDT | Power Supply |
3 | SCL | I2C clock input |
4 | NC | No connect |
5 | SDA | I2C data input and output |
6 | NC | No connect |
7 | RST | External Reset, Low is active |
8 | NC | No connect |
9 | INT | External interrupt to the host |
10 | VSS | Connect to system ground. |
規格説明
項目 | 仕様 | 単位 |
---|---|---|
サイズ(対角線) | 3.5 | インチ |
ドットマトリクス(解像度) | 320 × RGB × 480(TFT) | dots |
モジュールサイズ | 68.7 (W) × 95.6 (H) × 4.61(D) | mm |
有効エリア | 48.96 × 73.44 | mm |
ピクセルピッチ | 0.153 × 0.153 | mm |
LCDタイプ | TFT・ノーマルブラック・透過型 | |
視野角 | 80/80/80/80 | |
画面アスペクト比 | ポートレート | |
駆動IC | ILI9488 または同等 | |
インターフェイス | 1-Lane MIPI | |
バックライトタイプ | LED・ノーマルホワイト | |
PCAPドライバIC | GT911 或いは互換性IC | |
PCAPインターフェイス | I2C | |
FW バージョン | 0x95 | |
PCAP 解像度 | 320*480 | |
タッチパネルタイプ | PCAP静電容量タッチパネル | |
表面 | グレア |
絶対最大定格
項目 | 記号 | 最小値 | 典型値 | 最大値 | 単位 |
---|---|---|---|---|---|
動作温度 | TOP | -20 | - | 70 | ℃ |
保存温度 | TST | -30 | - | 80 | ℃ |
電気特性
項目 | 記号 | 条件 | 最小値 | 典型値 | 最大値 | 単位 |
---|---|---|---|---|---|---|
デジタル電源電圧 | IOVCC | - | - | 1.8/2.8 | 3.3 | V |
アナログ電源電圧 | VCI | - | - | 2.8 | 3.3 | V |
電源電流 | ICC | IOVCC=VCI =VCC=3.3V |
- | 13.6 | - | mA |
コメント
この記事へのトラックバックはありません。
この記事へのコメントはありません。